CRIIS - Indexed Articles in Conferences

Permanent URI for this collection

http://localhost:4000/handle/123456789/274

Browse

Browsing CRIIS - Indexed Articles in Conferences by Author "5240"
  • Item
    Driverless Wheelchair for Patient's On-Demand Transportation in Hospital Environment*
    ( 2020) André Rodrigues Baltazar ; Marcelo Petry ; Manuel Santos Silva ; António Paulo Moreira ; 5157 ; 5240 ; 5655 ; 7458
    The transport of patients from the inpatient service to the operating room is a recurrent task in the hospital routine. This task is repetitive, non-ergonomic, time consuming, and requires the labor of patient transporters. In this paper is presented the design of a driverless wheelchair under development capable of providing an on-demand mobility service to hospitals. The proposed wheelchair can receive transportation requests directly from the hospital information management system, pick-up patients at their beds, navigate autonomously through different floors, avoid obstacles, communicate with elevators, and drop patients off at the designated destination. © 2020 IEEE.
  • Item
    Evolution of odometry calibration methods for ground mobile robots
    ( 2020) Ricardo Barbosa Sousa ; Marcelo Petry ; António Paulo Moreira ; 5157 ; 5240 ; 7908
    Localisation is a critical problem in ground mobile robots. For dead reckoning, odometry is usually used. A disadvantage of using it alone is unbounded error accumulation. So, odometry calibration is critical in reducing error propagation. This paper presents an analysis of the developments and advances of systematic methods for odometry calibration. Four steering geometries were analysed, namely differential drive, Ackerman, tricycle and omnidirectional. It highlights the advances made on this field and covers the methods since UMBmark was proposed. The points of analysis are the techniques and test paths used, errors considered in calibration, and experiments made to validate each method. It was obtained fifteen methods for differential drive, three for Ackerman, two for tricycle, and three for the omnidirectional steering geometry. A disparity was noted, compared with the real utilisation, between the number of published works addressing differential drive and tricycle/Ackerman. Still, odometry continues evolving since UMBmark was proposed. © 2020 IEEE.
  • Item
    Extrinsic sensor calibration methods for mobile robots: A short review
    ( 2021) Ricardo Barbosa Sousa ; Marcelo Petry ; António Paulo Moreira ; 5157 ; 5240 ; 7908
    Data acquisition is a critical task for localisation and perception of mobile robots. It is necessary to compute the relative pose between onboard sensors to process the data in a common frame. Thus, extrinsic calibration computes the sensor’s relative pose improving data consistency between them. This paper performs a literature review on extrinsic sensor calibration methods prioritising the most recent ones. The sensors types considered were laser scanners, cameras and IMUs. It was found methods for robot–laser, laser–laser, laser–camera, robot–camera, camera–camera, camera–IMU, IMU–IMU and laser–IMU calibration. The analysed methods allow the full calibration of a sensory system composed of lasers, cameras and IMUs. © The Editor(s) (if applicable) and The Author(s), under exclusive license to Springer Nature Switzerland AG 2021.