Inscription of surface waveguides in glass by femtosecond laser writing for enhanced evanescent wave overlap

Abstract

Near-surface optical waveguides were fabricated in alkaline earth boro-aluminosilicate glass (Eagle2000), by femtosecond laser direct writing, using two distinct approaches. First, the capability of directly inscribing optical waveguides close to the surface was tested, and then, compared to the adoption of post writing wet etching to bring to the surface waveguides inscribed at greater depths. Laser ablation was found to limit the minimum surface to core center distance to 6.5 mu m in the first method, with anisotropic wet etching limiting the latter to 3 mu m without any surface deformation; smaller separations can be achieved at the cost of the planar surface topography. Furthermore, the waveguide's cross-section was seen to vary for laser inscription nearing the surface, observations that were also corroborated by its distinct guiding characteristics when compared to the adoption of post writing wet etching. The spectral analysis (in the 500-1700 nm range) also evidenced an increase in insertion loss for longer wavelengths and smaller surface to core center separations, caused, most likely, by coupling loss due to the interaction between the propagating mode and the surface. Different lengths of waveguide exposed to the surface were also tested, revealing that scattering loss due to surface roughness is not an issue at the centimeter scale.